Using The First Time Configuration Wizard On Gaia; Starting The Gaia First Time Configuration Wizard; Welcome; Available Releases - Check Point UTM-1 U-5 Getting Started Manual

Using the First Time Configuration Wizard on Gaia

Use the First Time Configuration Wizard to do the initial configuration of the Gaia appliance.
Note - The pages that you see in the wizard depend on the
software image and the options you select. You will not see
all the pages that are in this section.

Starting the Gaia First Time Configuration Wizard

To start the First Time Configuration Wizard:
1. Connect a standard network cable to the appliance management interface and to your
management network.
The management interface is marked INT. This interface is preconfigured with the IP
address 192.168.1.1.
2. Connect to the management interface from a computer on the same network subnet.
For example: IP address 192.168.1.x and net mask 255.255.255.0. This can be
changed in the WebUI, after you complete the First Time Configuration Wizard.
3. To access the management interface, open a connection from a browser to the default
management IP address: https://192.168.1.1
4. The login page opens. Log in to the system using the default username and password:
admin and admin
5. Click Login.
Note - The features configured in the First Time
Configuration Wizard are accessible after completing the
wizard using the WebUI menu. The WebUI menu can be
accessed by navigating to
https://<appliance_ip_address>.
6. The First Time Configuration Wizard runs.

Welcome

The Welcome page introduces the product.

Available Releases

The appliance comes with different software images. Select the software image that you want
to install. You can change to another software image after the First Time Configuration Wizard
is completed.
16 | UTM-1 Getting Started Guide