Summary; Installing The Smartconsole Gui Clients - Check Point UTM-1 U-5 Getting Started Manual

Centrally Managed Deployment
This section describes how to configure the appliance for centrally managed deployment.
Gateway Type
Configure the gateway type for a Centrally Managed UTM-1.
Web/SSH and GUI Clients Configuration
Define the clients that are allowed to connect to the appliance using a web browser or SSH
client. These clients can manage the appliance using a web or SSH connection.
You can define a Host according to Hostname or IP address. Enter a comma-separated list of
IP addresses from which you manage the appliance. Enter Any to manage the appliance from
anywhere.
Note - Do not use the Any value for security reasons.
After you complete the First Time Configuration Wizard, more options are available using the
WebUI menu.
SIC Setup
Configure the SIC (Secure Internal Communication) settings for a Centrally Managed
appliance. Enter a SIC Activation Key. The same key is used by the gateway object in
SmartDashboard.

Summary

The Summary page opens.
Click Finish to complete the First Time Configuration Wizard. You can log in to the appliance
after some minutes.
Note - You should back up the system configuration. Open
the WebUI interface and go to Appliance > Backup and
Restore.

Installing the SmartConsole GUI Clients

If SmartDashboard was downloaded during the First Time Configuration Wizard, skip to First
Time Login to the Security Management Server (on page 25).
24 | UTM-1 Getting Started Guide