Welcome; Appliance Date And Time Setup; Network Connections; Routing Table - Check Point UTM-1 U-5 Getting Started Manual

Welcome

The Welcome page summarizes the steps of the First Time Configuration Wizard.

Appliance Date and Time Setup

Configure date and time in the Date and Time Setup page. Click Apply.

Network Connections

Configure the network connections in the Network Connections page.
You can change the Management IP address. Connectivity is maintained with an automatically
created secondary interface. You can remove this interface after you complete the First Time
Configuration Wizard in the Network > Network Connections page.

Routing Table

Configure the routing settings on the Routing Table page.

Host, Domain Settings, and DNS Servers

Set the Host, Domain and DNS Servers in the Host, Domain Settings, and DNS Servers
page.
The host name must start with a letter and cannot be named com1, com2....com9.
In the DNS section, set the DNS servers for the appliance.
22 | UTM-1 Getting Started Guide