Configuring Utm-1; Installing Utm-1 In The Rack - Check Point UTM-1 U-5 Getting Started Manual

Chapter 2

Configuring UTM-1

In This Chapter
Installing UTM-1 in the Rack
Connecting Power Cables and Powering On
Available Software Images
Initial Configuration
Using the First Time Configuration Wizard on Gaia
Using the First Time Configuration Wizard on SecurePlatform
Installing the SmartConsole GUI Clients
First Time Login to the Security Management Server
Configure and Install the Security Policy
Advanced Configuration
To configure UTM-1, perform the following steps:
Step 1: Install UTM-1 onto the rack.
Step 2: Connect the cables and power on.
Step 3: Use the First Time Configuration Wizard.
Step 4: Install the SmartConsole GUI clients.
Step 5: Login to SmartDashboard and compare the fingerprint.
Step 6: Configure and install the security policy.

Installing UTM-1 in the Rack

Note - Does not apply to UTM-1 130.
Install the system in the rack with the network ports facing the front of the rack.
UTM-1 Getting Started Guide
13
14
14
14
16
21
24
25
25
28
| 13