Table of Contents
Advertisement
LPX SEED TREATER
H-O-A (HAND-OFF-AUTO) SCREEN
3. SEED WHEEL CONTROL MODULE:
This module controls the function of the
seed wheel. Pressing the button while START is displayed will cause the seed wheel
to turn on and the background will turn green. Pressing this button again will shut off
the seed wheel. (This module is only available if the treater is utilizing a seed wheel)
4. INLET CONVEYOR CONTROL MODULE:
This module controls the function of
the inlet conveyor. Pressing the button while START is displayed will cause the inlet
conveyor to turn on and the background will turn green. Pressing this button again will
shut off the inlet conveyor.
5. OUTLET CONVEYOR CONTROL MODULE:
This module controls the function of
the outlet conveyor. Pressing the button while START is displayed will cause the outlet
conveyor to turn on and the background will turn green. Pressing this button again will
shut off the outlet conveyor.
6. DRUM PERCENT SPEED MODULE:
When this button is pressed, a numeric
touch pad (bottom) will appear to allow the operator to manually adjust the speed of
the drum.
7. ATOMIZER PERCENT SPEED MODULE:
When this button is pressed, a numeric
touch pad (bottom) will appear to allow the operator to manually adjust the speed of
the atomizer.
8. RETURN BUTTON:
This button returns the operator to the startup screen.
9. CALIBRATION BUTTON:
This button takes the operator to the Calibration screen.
(see page 39).
10. SEED WHEEL RPM DISPLAY:
This display shows the current RPMs of the
seed wheel.
11. SEED WHEEL RPM MODULE:
When this button is pressed, a numeric touch
pad will appear to allow the operator to manually adjust the speed of the seed wheel
(This module is only available if the treater is utilizing a Seed Wheel).
12. PUMP / AUX CONTROL MODULE:
This module allows the operator to control
any unit or pump which is plugged into the auxiliary port located on the bottom of the
treater main control panel located on the seed treater. The HAND button will allow
the user to operate the unit in the manual mode of operation. The OFF button will
disconnect control to the auxiliary port. The AUTO button will place the unit in the
automatic mode of operation and will send a signal to turn on the associated device
when seed is present.
Page 37
Advertisement
Table of Contents
