Laser Maintenance Schedule; Focal Lens; Mirror #3 - BOSSLASER LS Series Operator's Manual

Laser Maintenance Schedule

Focal Lens:

This is the lens that is used to focus the laser beam and it should be cleaned at least once per week. It is NOT possible to
clean the lens while it is mounted in the focal lens tube. The laser beam alignment should be checked after the cleaning
of the lens has been completed. If there is any type of fire or large issue with smoke or fumes, it is advised to check the
lens and clean it.
When cleaning the lens, use denatured alcohol as the cleaning solvent, use a lens tissue or cotton swabs to apply the
solvent. Lens cleanings alcohol free wipes will also do the trick but, we recommend having a BossLaser Lens Cleaning Kit,
which can be purchased on our website.DO NOT scrape the lens, only use soft fabrics and approved solvents when
cleaning the lens. Only use a soft swirling motion when applying the solvent then use a dry swab in a soft swirling motion
to evaporate the solvent completely.
The lens surface is somewhat difficult to see in normal lighting. In order to see any dirt on the lens, look at the reflection
in the lens. (Think of this like when you take glasses off your face to see any smudges or scratches in the lenses, you
usually can't see them until you've held them away from your face and in a different angle of light.
Make sure not to leave any dirt, smudges, or water on your focal lens. The focal lens should be replaced if it is cracked,
chipped, the coating is scratched, the core of the lens is darkened, the coating is wearing off or any other significant
damage is found that could impact the laser beam passing through the focal lens. Some minor blemishes are acceptable,
but these problems waste power and will result in reduced laser power at the target material. Any dirt, contaminate, or
damage to the lens will cause the lens to deteriorate more quickly.

Mirror #3:

This mirror is in the laser head and located directly above the focal lens and needs to be cleaned at least once a month.
If there is any incident of fire or any large amounts of smoke or fumes, itis advised to check the mirror and clean it. It is
possible for this mirror to be cleaned in the mounting bracket but, it is highly advised that the mirror be removed from
the bracket and cleaned thoroughly.
When cleaning the mirror, use denatured alcohol as the cleaning solvent, use a lens tissue or cotton swabs to apply the
solvent. Lens cleanings alcohol free wipes will also do the trick but, we recommend having a BossLaser Lens Cleaning Kit,
which can be purchased on our website. DO NOT scrape the mirror, only use soft fabrics and approved solvents when
cleaning the mirror. Only use a soft swirling motion when applying the solvent then use a dry swab in a soft swirling
motion to evaporate the solvent completely.
Make sure not to leave any dirt, smudges, or water on your focal mirror. The mirror should be replaced if it is
pitted/scratched, rusted, discolored from heat damage, or any other significant damage is found. Some minor blemishes
are acceptable, but these problems waste power and will result in reduced laser power at the target material. Any dirt,
contaminate, or damage to the mirror will cause the lens to deteriorate more quickly.
Document Number: 855-901 Revision: 003 Revision Date: 11/14/2022 BOSSLASER Page 42 of 48