Main Switches & Controls
Emission Indicator
The emission indicator can be seen in the image above to the far left. The emission indicator is a safety feature and will
glow red when the machine is emitting a laser beam.
Milliamp Gauge
The milliamp gauge can be seen in the top middle in the picture located above. This gauge will show the output of the
laser beam in milliamps. Technical Support may ask you to reference this gauge for troubleshooting purposes.
Temperature Gauge
The temperature gauge can be seen in the bottom middle of the picture shown above. This temperature gauge will read
the temperature of the water going through the tube. It is important to pay attention to this gauge as the temperature
of your water should be between 68°- 77° Fahrenheit (20°- 25° Celsius).
Key Control
The Key Control can be seen in the top right of the image above. The key ignition is where you will insert your ignition
key and turn the key, turning on the machine. If the machine is not in use, the key should be removed and put in a safe
and secure location to prevent any unauthorized use.
Emergency Stop
The Emergency Stop button can be seen in the bottom right of the image above. The Emergency Stop is a safety feature
and should be used in case of an emergency. If the button is engaged, it will be pushed down. If the emergency stop is in
the up position, it is disengaged. For your machine to turn on, the Emergency Stop must be disengaged.
Document Number: 855-901
Revision: 003
Revision Date: 11/14/2022
BOSSLASER
Page 29 of 48