Table of Contents
Advertisement
Main Switches & Controls
USB-B Data Cable & Ethernet Cable
The USB-B & Ethernet cable can be found on the right-hand side of your laser machine.
USB-B Data Cable – The USB-B Data Cable can be seen in the image below on the left-hand side. This
port is used to connect your computer to the laser machine, allowing you to send files from the
computer to the laser machine.
Ethernet Cable – The Ethernet Cable can be seen in the image below on the right-hand side and is used
for network connection and Wi-Fi networking when applicable.
Light Switch
The Light Switch can be found on the right-hand side of your machine. This rocker switch is to turn on
and turn off the lights located within your laser machine.
Main Control Panel
The control panel of your machine is where you have the
capability to make changes to the parameters and settings of
your machine and your files. A USB port is located at the top
right-hand side of the Control Panel, this is where you will
insert your USB dongle to send files to the machine instead of
a cable connection. If you want to use a dongle USB and plug
it into the control panel, the files must be saved as .ud5 in
order for the machine to read the files.
Document Number: 855-901
Revision: 003
Revision Date: 11/14/2022
BOSSLASER
Page 30 of 48
Advertisement
Table of Contents
