Safety Features & Regulatory Compliance
Laser Tube Handling
The "DANGER: Laser Radiation" label and the "Laser Aperture" label can be found on the laser tube, which will be located
on the backside of the machine in the rear/top access panel. The laser beam will be initiated in the laser tube itself and
it is important to have all panels and access doors closed prior to firing the laser. Also, make sure to disconnect your
machine from any power source prior to handling the laser tube or its' components. Protective eye wear and clothing
must be worn if any access panels or doors are open while operating the machine.
Document Number: 855-901
Danger Fire Hazard
The "DANGER FIRE HAZARD" warning label can be found on the top right- side of your
machine above the LCD Screen and it is crucial to the health of your machine. The laser beam
emitted from the machine is extremely hot and can cause any material to catch on fire. DO
NOT leave the machine unattended while the machine is firing. Any fire that arises due to
disregarding this warning is not covered by the warranty and any damages will be at the cost
of the machine owner.
Revision: 003
Revision Date: 11/14/2022
BOSSLASER
Page 15 of 48