Troubleshooting; Laser Not Turning On; Machine Is Turning On But Not Firing; Or Y Slop Over Error/ Frame Over Error - BOSSLASER LS Series Operator's Manual

Troubleshooting

Laser Not Turning On:

First, make sure that the electrical outlet is working, plug in a lamp or phone charger to ensure that itis the machine and
not the outlet. Check the simple stuff first.
•
Is the emergency stop button pressed?
•
Is the key in the machine and turned into the on position?
•
Is the cord plugged into the machine and electrical outlet?

Machine is Turning on but Not Firing:

The laser has multiple protection modes built in to prevent possible injuries or damage to the machine. Problems with
any of these modes can prevent the machine from firing but, the laser head will still move around as if the machine is
working correctly.
•
Check to see if the chiller or water pump is working and flowing water throughout the tube. If no water flow is
detected by the machine, it will not fire. If you are using a water pump, make sure your chiller bypass cable is
plugged in.
•
Ensure that all the cabinet doors and machine hood is closed, our machines come with interlocks to prevent the
machine operating when the doors or hood are open.
•
Check to see if the exhaust fan is on and working, the machine will not fire without it.
X or Y Slop Over Error/ Frame Over Error:
When running the "Frame" and/or "Start-Pause button, the slop/frame error message will appear only if the object(s)/
image(s) being executed on the worktable is overextending (too big or not enough space on the worktable for the file to
be done).

The File Is Starting at the Same Spot Every Time:

In most cases, this happens when the "Origin" was accidently selected. To cancel the origin, press the "Z/U" key and cycle
through the options until you see "Axis Reset+" is highlighted. Select it and then highlight over the "XY Axis Reset". Once
that is selected, the laser head will go to its home position and
now the origin has been cancelled. To change the origin position, just move the laser head to your desired location, then
press the "Origin" key again to set the origin.
Document Number: 855-901 Revision: 003 Revision Date: 11/14/2022 BOSSLASER Page 45 of 48