Water Pump; Water Chiller; Setting Up Your Water Chiller - BOSSLASER LS Series Operator's Manual

Water Pump

All Boss Laser laser tubes are water-cooled, and the
machine will not fire if the water is not going
through the tube. Distilled water is highly
recommended.
The water pump requires two lines, one to the
water reservoir and one to the water out barbed
fixture. This water pump is designed to rest on the
bottom of a container filled with at least 4gallons of
distilled water. A simple solution for this would be
to use a 5- gallon bucket with three holes in the lid
for 1/2" flexible hose lines and power cord. Make
sure not to get the lines reversed
There will be a gold nozzle located in the water pump box, this will attach to the threaded opening located at the top of
the water pump. Once the nozzle is attached, take the first line of tubing, and place it over the nozzle and then place the
other end of the tubing onto the fitting on the back of the machine that says, "water in". Your second line of flexible
tubing will need to be put on the fitting that says, "water out" and the other end of the tubing will need to flow back into
the 5-gallon bucket. Finally, plug in your water pump and place it into the bucket of water.

Water Chiller

Setting up Your Water Chiller

Remove the water chiller from the box and remove all
packaging materials. Your LS machine will come with
two (2) pieces of silicone tubing, a water chiller signal
cable, and a power cord. This tubing & cord should be
located in the box your water chiller came in. You also
will need a minimum of 3 gallons of distilled water.
To attach your water chiller to your machine, place the water chiller next to the machine, preferably on the right-hand
side of the machine, next to your "Water In" & "Water Out" ports located on the backside of the machine.
Document Number: 855-901 Revision: 003 Revision Date: 11/14/2022 BOSSLASER Page 25 of 48