Display Operation - LifeSpan BOOMER User Manual

3.4 Display Operation

(1) START/STOP, press this button to start or stop the machine
a. When the operation panel is in standby, press START/STOP button, the treadmill will
start after 3 seconds, and the time window counts down for 3 seconds. The
Treadmill will start operating at the lowest speed---0.1km/h, press the start/stop
button again to stop the machine.
b. After the window values are set, press START/STOP button to start the machine and
run at set speed or mode.
c. After starting the machine, if there's Pulse signal input. Calorie/Pulse window
displays pulse.
(2) Reset
a. When setting, if one window is incorrect or the setting is modified, please reset the
window by pressing Reset button.
b. Reset key is not available after starting the machine
(3) Speed + /Speed
a. After starting the machine, press Speed+ to increase the speed from 0.8km/h to
12.0km/h press Speed+/Speed- once, the speed increases/decreases 0.1km/h;
When the SPEED increases to 12km/h, Speed+ key is unavailable. When SPEED
decreases to 0.1km/h, Speed – key is unavailable. Hold Speed+/Speed- for over 0.5
seconds, the speed will change rapidly.
b. In Select mode, press Speed+/Speed- to adjust the value of different windows
under flash state.
c. After starting the treadmill, press Speed+/Speed- to change the speed value and
the Speed window won't flash.
d. In Set mode, hold Speed+/Speed- for over 0.5 seconds, the speed will change
rapidly.
(4) Select
a. Before starting the machine, press Select key to select Speed. Time, Distance,
Calorie window, the selected window SET flashes. It will stop flashing if there isn't
input within 6 seconds.
LIFESPAN BOOMER Page 8