EAS Electric EFMV2 Series Instruction Manual page 41

CLEANING AND MAINTENANCE WARNINGS
Turn off the device and disconnect the power before cleaning. Failure to do
so can cause electrical shock.
Do not clean the air conditioner with excessive amounts of water.
Do not clean the air conditioner with combustible cleaning agents.
Combustible cleaning agents can cause fire or deformation.
CAUTION
Turn off the air conditioner and disconnect the power if you are not going to use it
for a long time.
Turn off and unplug the unit during storms.
Make sure that water condensation can drain unhindered from the unit.
Do not operate the air conditioner with wet hands. This may cause electric shock.
Do not use device for any other purpose than its intended use.
Do not climb onto or place objects on top of the outdoor unit.
Do not allow the air conditioner to operate for long periods of time with doors or
windows open, or if the humidity is very high.
ELECTRICAL WARNINGS
 Only use the specified power cord. If the power cord is damaged, it must be
replaced by the
order to avoid a hazard.
Keep power plug clean. Remove any dust or grime that accumulates on or

around the plug. Dirty plugs can cause fire or electric shock. Do not pull power
cord to unplug unit. Hold the plug firmly and pull it from the outlet. Pulling
directly on the cord can damage it, which can lead to fire or electric shock.
Do not modify the length of the power supply cord or use an extension cord to

power the unit. Do not share the electrical outlet with other appliances.
Improper or insufficient power supply can cause fire or electrical shock.
The product must be properly grounded at the time of installation, or electrical

shock may occur. For all electrical work, follow all local and national wiring
standards, regulations, and the Installation Manual. Connect cables tightly, and
clamp them securely to prevent external forces from damaging the terminal.
Improper electrical connections can overheat and cause fire, and may also
cause shock. All electrical connections must be made according to the Electrical
Connection Diagram located on the panels of the indoor and outdoor units.
All wiring must be properly arranged to ensure that the control board cover can

close properly. If the control board cover is not closed properly, it can lead to
corrosion and cause the connection points on the terminal to heat up, catch fire,
or cause electrical shock.
If connecting power to fixed wiring, an all-pole disconnection device which has

at least 3mm clearances in all poles, and have a leakage current that may
exceed 10mA, the residual current device(RCD) having a rated residual
operating current
incorporated in the fixed wiring in accordance with the wiring rules.
TAKE NOTE OF FUSE SPECIFICATIONS
The air conditioner's circuit board (PCB) is designed with a fuse to provide
overcurrent protection. The specifications of the fuse are printed on the circuit
manufacturer, its service agent or similarly qualified persons in
not exceeding 30mA, and disconnection
4
must be
V.1