Non-Responsive Power Button - Advantech PAX-324-C2 User Manual

B.1

Non-Responsive Power Button

Unplug the power cord from the AC outlet to power off and reset the monitor.

B.2 No Picture
Check that the signal cable is securely connected to the monitor and to the dis-

play source device.
Check that the monitor and the display source device are powered on.

Check that the monitor and display source device are configured to the correct

display mode.
Check that the monitor is compatible with the display card and the settings are

all configured correctly.
Check that the signal cable connector pins are not bent or pushed in.

Check that the monitor's signal input settings are correctly configured.

B.3 No Video
If no video is displayed on screen, turn the monitor power off and on again.

Ensure that the monitor and display source device are not in power-saving

mode.
B.4 Image Persistence
Image persistence refers to when a residual or "ghost" image of a previous

image remains visible on screen. Unlike CRT monitors, with LCD monitors
image persistence is not permanent. However, displaying constant images for
long periods of time should be avoided.
To alleviate image persistence, power off the monitor for the same length of

time as the image was displayed. For example, if an image was displayed on
the monitor for one hour and a residual image remains, the monitor should be
powered off for one hour to erase the image.
Note! As with all personal display devices, Advantech recommends using a
moving screen saver whenever the screen is idle and turning off the
monitor when not in use.
B.5 Unstable, or Unfocused Image
Check that the signal cable is securely connected to the monitor and to the dis-

play source device.
Check that the monitor is compatible with the display card and the settings are

all configured correctly.
If text is presented on screen in a garbled manner, change the display mode

and set the refresh rate to 60Hz.
B.6 Incorrect Display Image Size
Check that the monitor and display source device are configured to the correct

display mode (refer to the display card or monitor user manual when changing
graphics mode).
PAX-324-C2 User Manual 34