Table of Contents
Advertisement
2.2
Installation Procedures
2.2.1
Connecting the Power Cord
The PDC-W240 can only be powered by a DC power adapter (FSP Model
DHBM1
). Be sure to always handle the power cords by holding the plug ends only.
Follow these procedures in order:
1.
Connect the female end of the power adapter to the DC jack of the panel PC.
(See Figure 2.4.)
2.
Connect the female end of the power cord to the DC power adapter.
3.
Connect the 3-pin male plug of the power cord to an electrical outlet.
2.2.2
Connecting the Ground Pin
Step 1. System ready and find the Equipotential Terminal on rear side of PDC.
An Equipotential Terminal is provide to optionally connect to a hospital
Figure 2.4 Connecting the power cord
ground/earth system
FSP065-
Advertisement
Table of Contents
