Software Signal Pulse And User Output - Photon Focus Gpixel MV8 Series User Manual

4.7 Software Signal Pulse and User Output

The software signal pulse block contains eight general purpose registers which allow
generating internal pulse signals by software access. These pulse signals are internally
connected to following functions, where it can be used to start a procedure:
• Acquisition Start Trigger
• Acquisition End Trigger
• Frame Start Trigger
• Frame Burst Start Trigger
• Frame Burst End Trigger
• Exposure Start Trigger
• Exposure End Trigger
• Counter Trigger
• Counter Event
• Encoder Reset
• Counter Reset
• Timer Trigger
The user output block is an eight bit status register. The bits can be set to 0 or 1 by software.
The bits are available in the following firmware blocks/functions:
• Counter Trigger
• Counter Reset
• Encoder Reset
• LED S0 and S1
• Line Out
MAN094 02/2022 V1.1
4.7 Software Signal Pulse and User Output
41 of 141