Single-Ended Line Input - Photon Focus Gpixel MV8 Series User Manual

13 Hardware Interface
If an error condition has been detected on an input and signalized by the Line-
Fault parameter, it must be acknowledged by the LineFaultAcknowledge command
in order to use or reconfigure the corresponding input again.
Parameter LineFaultUpdate must be performed in order to update the error state.

13.7.3 Single-ended Line Input

LineIn0, LineIn1 or LineIn2 can be configured as single-ended input (Table 13.8 lists the
available standards). Fig. 13.6 shows two examples, how a single-ended configured input can
be used.
Figure 13.6: Example of input connections
The inputs must be driven by a push-pull stage or an open drain output with a
pull-up resistor.
.
104 of 141
17-pin M12
I/O Connector
YOUR_POWER
TTL or SE-HTL
ISO_IN0
3
&
YOUR_GND
4
ISO_IN1
5
YOUR_POWER
4.7k
6
ISO_IN2
7
YOUR_GND 8
TTL120
ISO_IN3
9
17
YOUR_GND
Isolator
C0
LineIn0
R0
C1
LineIn1
R1
C2
LineIn2
R2
10nF
LineIn3
120
¡
ISO_GND
Camera
MAN094 02/2022 V1.1