Photon Focus Gpixel MV8 Series User Manual page 48

5 Counter & Timer
Acquisition End Resets with the reception of the acquisition end event.
FrameTrigger Resets with the reception of the frame trigger.
Frame Start Resets with the reception of the frame start event.
Frame End Resets with the reception of the frame end event.
Frame Burst Start Resets with the reception of the frame burst start event.
Frame Burst End Resets with the reception of the frame burst end event.
Exposure Start Resets with the reception of the exposure start event.
Exposure End Resets with the reception of the exposure end event.
User Output 0 ... 7 Resets the counter as long as the selected user output bit is asserted. The
counter remains in reset state until the selected user output bit is deasserted again (see
Section 4.7).
Counter 0 ... 3 Start Resets with the reception of the chosen counter start event.
Counter 0 ... 3 End Resets with the reception of the chosen counter end event.
Timer 0 ... 3 Start Resets with the reception of the chosen timer start event.
Timer 0 ... 3 End Resets with the reception of the chosen timer end event.
Encoder Resets with the reception the encoder trigger event.
Action 0 ... 3 Resets with the reception of the chosen action signal event.
Software Signal Pulse 0 ... 7 Resets with the reception of chosen software signal pulse event
(see Section 4.7).
Line Input Resets when the specified counter trigger activation condition is met on the chosen
line.
Line input source has additionally a activation configuration, which needs to be set
accordingly. Following configuration values are available:
Rising Edge Resets with the rising edge on the selected line input.
Falling Edge Resets with the falling edge on the selected line input.
Both Edges Resets with any edge on the selected line input.
Activation configuration has only effect when line input is selected as a counter
reset source, otherwise this configuration is ignored.
48 of 141
MAN094 02/2022 V1.1