Bompani BI640YB/P Operating And Installation Instructions page 71

ADJUSTMENT OF FEET
Your oven stands on 4 adjustable feet. When the oven is placed where it will be used, check if the
oven is balanced. If it is not balanced, you can make the adjustment by turning the feet clockwise if required.
It is possible to raise the appliance maximum 5mm by the feet. If the feet are adjusted appropriately, it is
required not to move the appliance by dragging, it should be moved by lifting it up.
GAS CONNECTION
The connection of the appliance should be performed in accordance with local and international
standards and regulations applicable. You can find the information related to appropriate gas types and
appropriate gas injectors on technical data table. If the pressure of used gas is different than these values
stated of the or not stable in your area, it is required to affix an available pressure regulator on the gas inlet.
It is certainly required to contact to the authorized service to make these adjusments.
If the gas connection is made by a flexible hose that is fixed on the gas inlet of appliance, it must
be fixed by a pipe collar as well. Connect your appliance with a short and durable hose that is as close as
possible to the gas source. The hose's permitted maximum lenght is 1.5m. The hose that brings gas to the
appliance must be changed once a year for your security.
The points that must be checked during flexible hose assembly
The hose must be kept clear from areas that may heat up to temperatures in excess of 50C. The
hose must not be ruptured, bent or folded. The hose must be kept clear of sharp corners, moving things,
and should not be defective. Before assembly, it must be checked whether there is any production defect.
As gas is turned on, all connection parts and hose must be checked with bubbly water or leakage fluids. Do
not use naked flame to check gas leakage. All metal components used during gas connection must be clear
of rust. Also check the expiry dates of components used.
The points that must be checked during Fixed gas connection assembly
To assemble a fixed gas connection (gas connection made by threads, e.g. a nut), there are
different methods used in different areas. The most common parts are already supplied with your
appliance. Any other part can be supplied as spare part.
During connections always keep the nut on the gas manifold fixed, while rotating the counter-
part. Use spanners of appropriate size for safe connection. For all surfaces between different components,
always use the seals provided in the spare set. The seals used during connection should also be approved
to be used in gas connections. Do not use plumbing seals for gas connections.
Remember that this appliance is prepeared to be connected to gas supply in the country for
which it has been produced. The main country of destination is marked on the rear cover of the appliance. If
you need to use it in another country, any of the connections in the figure below can be required. In such a
case, contact local authorities to learn the correct gas connection.
It is required to call the authorized service to be able to make the gas connections appropriately and in
compliance with safety standards.
ATTENTION Surely do not use any match and lighter for control of gas leakage.
5