Table of Contents
Advertisement
Viewing reports
To view system status reports for the control panel and connected devices,
select Reports from the Main menu. Report information for this user level is
shown in the table below.
Table 12: Reports available to operator users
Report
Event log
Attention required
Revision
Contact details
Zone status [1]
Device status [1]
Panel I/O status
Output groups status [1]
Rules status
Firenet status
[1] These reports are not available on repeater panels.
[2] A rule consists of one or more states (combined by Boolean operators) that are configured to
trigger specific system actions after a specific confirmation time. Rules are created by your
installation or maintenance contractor.
Note:
To check the firmware version of your control panel, select Revision report
and then select Firmware version.
28
Description
Displays all alarm, fault, and condition events logged by the
control panel
Displays all devices reporting a fault condition
Displays your control panel software revision, control panel
configuration revision, and system boards serial number data
Displays contact information for your installation or
maintenance contractor (subject to installer configuration)
Displays the current status information for zones
Displays the current status information for control panel
devices
Displays the current status information for the control panel
inputs and outputs
Displays the control panel output groups (sounders, fire
routing, fire protection, or program) that are currently active
Displays the control panel rules that are currently active [2]
Displays the current status for all control panels in the fire
network
ZP2-A Series Operation Manual
Advertisement
Table of Contents
