Conditions - Ziton ZP2-AF1-S Operation Manual

Conditions

A summary of system events logged as conditions is shown below.
Table 9: System events logged as conditions
Condition type
Alert
Configuration device connected
Date and time not set
Change password
Disablements
Event log full
Extinguishing status [1]
Extinguishing I/O device [1]
Incompatible firmware version
Input activation
Loop device not configured
Loop power
Loop recovery
Maximum conventional zones
exceeded in a network
Maximum loops exceeded in a
network
New node in the fire network
Output group activation
Prealarm
Sounder, fire routing, and fire
protection delays
Tests
[1] These condition types only apply if an extinguishing panel is included in the fire network.
14
Description
A device is in alarm but the system is waiting for an
additional alarm event to confirm the zone alarm
A control panel configuration session is initiated via an
external device (PC, laptop, etc.)
The system started but the date and time are not set
The default Operator, Maintenance, or Installer password
should be changed.
A control panel feature or device is disabled
The control panel event log is full
Extinguishing is blocked, disabled, or has a fault
An extinguishing I/O device is active, being tested, is
disabled, or has a fault
An expansion board (for example, a loop board, a network
board, or DACT board) has an incompatible firmware
version. The control panel firmware version should be
updated.
An input is activated (subject to configuration)
A loop device is detected that is not configured
A loop power status is OFF
A loop is in the recovery process (this may happen when a
short circuit fault is detected or after a reset if there was a
fault on the loop).
The number of conventional zones in a fire network
exceeds the maximum allowed
The number of loops in a fire network exceeds the
maximum allowed
A control panel has been added to the fire network
An output group is activated
A device (and corresponding zone) is in prealarm
A sounder, fire routing, or fire protection delay is enabled or
disabled
A control panel feature or device is being tested
ZP2-A Series Operation Manual