RDL-3000 Connect-OW-OW
4
Installation
This section describes installation of the Connect-OW wireless terminal, PoE power
injector and surge suppression device. The installer will need to complete the following
activities as part of the installation procedure for the Connect-OW radio.
Installation Steps
4.1 Preparation
1. Review the system installation overview
2. Review the Site Survey section to ensure all installation requirements are
complete and all installation materials are available.
3. Assemble Radio mounting bracket.
4. Assemble and Weatherproof Ethernet Port Connection
4. 2 Install Outdoor Equipment
1. Install Connect-OW on Mast
2. Coarse Antenna Alignment
4.3 Install In-Cabinet Equipment
1. Install PoE Power Injector
2. Install Ethernet Surge Arrestor
4.4 Configure System Operating Parameters
1. Required Materials
2. Establish Communications with Test PC
3. install Options Key
4. Network and RF settings
5. Medium/Fine antenna Adjustment
70-00200-01-00
Installation Guidelines
Proprietary Redline Communications © 2014
Chapter 4
Page
35
of 58
December 3, 2014