Sas 9260-8I/Sas 9260De-8I Raid Controller - Jumpers - LSI MegaRAID SAS 9240-4i User Manual

Table 3.2 SAS 9260-8i/SAS 9260DE-8i RAID Controller – Jumpers
and Connectors
Jumper Type
JT1
Write-pending Indicator
(dirty cache) LED
connector
JT2 SAS Activity LED header 2-pin connector
JT3 Battery Backup Unit
connector
JT4 Global Drive Fault LED
header
JT6 x4 SAS Ports 3–0
JT7 x4 SAS Ports 7–4
Note: The SAS 9260-4i
RAID controller
does not have this
connector.
JT8 Modular RAID Key
header
JT9 Set Factory Defaults
connector
JT10 LSI Test header
MegaRAID 6Gb/s SAS RAID Controller Family
Copyright © 2009 by LSI Corporation. All rights reserved.
Description
2-pin connector
Connects to an LED that indicates when the
data in the cache has yet to be written to the
storage devices. Used when the write-back
feature is enabled.
Connects to an LED that indicates drive
activity.
20-pin connector
Connects the intelligent Battery Backup Unit
LSIiBBU07 remotely to the RAID controller.
2-pin connector
Connects to a single LED to indicate
whether any drive is in a fault condition.
SFF-8087 x4 internal mini SAS connector
Connects the cables from the RAID
controller to SAS drives, SATA II drives, or a
SAS expander.
SFF-8087 x4 internal mini SAS connector
Connects the cables from the RAID
controller to SAS drives, SATA II drives, or a
SAS expander.
2-pin connector
Reserved for LSI use.
2-pin connector
Reserved for LSI use.
2-pin connector
Reserved for LSI use.
3-5