Card Layout For The Megaraid Sas 9240-8I Raid Controller - LSI MegaRAID SAS 9240-4i User Manual

3-2
Note: The SAS 9240-4i RAID controller does not contain the J5
connector, which supports ports 4–7. The SAS 9240-8i
RAID controller contains the J5 connector.
This subsection provides the board layout and connector and jumper
information for the RAID controller.
connectors on the SAS 9240-8i RAID controller.
Figure 3.1 Card Layout for the MegaRAID SAS 9240-8i RAID
Controller
J4
Table 3.2 describes the jumpers and connectors on the SAS 9240-4i and
9240-8i RAID controllers.
MegaRAID SAS RAID Controller Characteristics
Copyright © 2009 by LSI Corporation. All rights reserved.
Figure 3.2
J5
J6
shows the jumpers and
J2
J3
85043-00