Table of Contents
Advertisement
2-4
Note:
Some PCI-E slots support PCI-E graphics cards only; if a
RAID controller is installed on those PCI-E slots, it will not
function.
Figure 2.1
Example of the MegaRAID SAS 9260-8i Board
Installation in a PCI Express Slot
Press here
85039-05
Edge of
Motherboard
Step 5. Configure and Install the SAS Devices, SATA II Devices, or
Both in the Host Computer Case
Refer to the documentation for the devices for any
preinstallation configuration requirements.
Step 6. Connect the RAID Controller to the Devices
Use SAS cables to connect SAS devices, SATA II devices, or
both to the MegaRAID 6Gb/s SAS RAID controller.
See
Section 2.5, "SAS Device Cables and Connectors"
cable and connector information. See
"Connecting a SAS RAID Controller with Internal Connectors to
Drives,"
for information about connecting the controller to drives.
MegaRAID SAS Hardware Installation
Copyright © 2009 by LSI Corporation. All rights reserved.
Bracket Screw
Press here
32-bit slots
(3.3 V)
PCI-e
slot
64-bit slots
(3.3 V)
Section 2.5.1,
for SAS
Hide quick links:
Advertisement
Table of Contents
