Card Layout For The Megaraid Sas 9260-8I Raid Controller - LSI MegaRAID SAS 9240-4i User Manual

3-4
The MegaRAID SAS 9260-8i low-profile SAS/SATA II RAID controller
controls eight internal SAS/SATA ports through two SFF-8087 x4 internal
mini SAS connectors.
The MegaRAID SAS 9260DE-8i low-profile SAS/SATA II RAID controller
controls eight internal SAS/SATA ports through two SFF-8087 x4 internal
mini SAS connectors and offers data security using disk encryption.
Note: The SAS 9260-4i RAID controller does not contain the JT7
connector, which supports ports 4–7. The SAS 9260DE-8i
has the same connectors as the SAS 9260-8i.
This subsection provides the board layout, and connector and jumper
information for the RAID controller.
connectors on the SAS 9260-8i RAID controller.
Figure 3.2 Card Layout for the MegaRAID SAS 9260-8i RAID
Controller
JT10
JT7
JT12
Port
JT9
7-4
JT13
JT11
JT8
85039-04
Note: JT1, JT2, and JT4 are behind the LSIiBBU07 when the
iBBU is installed, but they are still accessible.
Table 3.2 describes the jumpers and connectors on the SAS 9260-8i and
9260DE-8i RAID controllers.
MegaRAID SAS RAID Controller Characteristics
Copyright © 2009 by LSI Corporation. All rights reserved.
Figure 3.2
JT6
Port
3-0
shows the jumpers and
JT2
JT1
JT4
JT3