Advertisement
5.2.13 Connecting the power cable and control cable to the control unit
▶ Connect the power cable and control cable and secure the plugs.
5.3 Operation and sawing
5.3.1 Setting the starting cutting pressure
1. Set the saw advance pressure on the control unit to the recommended value, tension
the wire by adjusting the advance control valve and check that the sawing wire can
be pulled easily through the kerf by hand.
2. Set the advance pressure (1).
3. Operate the advance control valve (2).
5.3.2 Starting
WARNING
Caution Switch off the drive if the sawing wire slips.
▶ Switch the main drive off right away if the wire doesn't move immediately after
starting. Slippage of the sawing wire causes damage to the drive wheel.
28
English
Advertisement
