Advertisement
1. First pass the sawing wire through the object to be cut and then round off any corners
or edges in the path of the wire by pulling the wire back and forward manually until it
can be moved easily by hand.
2. Feed the sawing wire through the hollow axles (1) of the pulley stands and then
through the hollow axles of the pulley bearer on the wire saw.
3. Place the sawing wire on the pulleys (2) and on the drive wheel (3) and then tension
the wire slightly by moving the drive unit (release the piston rod lock).
4. Lock the drive unit (3) in position.
5. Release the return stop (4), push the piston rod all the way in and then lock the piston
rod and return stop (5).
◁ The return stop prevents slackening of the sawing wire due to elastic movement of
the piston rod when starting the saw.
6. After securing the return stop, release the advance lock.
5.2.10 Fitting the guards
WARNING
Caution The end stop must be fitted correctly.
▶ Do not, under any circumstances, use the saw without a correctly fitted end
stop..
26
English
Advertisement
