Advertisement
3.3.9 Control unit operating controls
"Ready for operation" indicator
@
(lights green)
Fault indicator (lights red)
;
Gauge showing current input in
=
amps
Gauge showing advance pressure
%
in bar
Advance pressure regulator (lift
&
knob to unlock)
3.4 Intended use
This equipment complies with IEC 61000-3-12 provided that the short-circuit power S
at the interface point between the user's supply and the public supply network is greater
than or equal to 350. It is the responsibility of the installer or user of the equipment to
ensure, by consultation with the public supply network operator, that the equipment is
connected only to a supply with a short-circuit power S
The wire saw is designed for the technical demolition of steel, concrete, stone or
brickwork structures in construction and civil engineering applications. Use extending
beyond this is considered to be not as directed and requires to be clarified in advance
with the manufacturer.
The operator in charge must be aware of the possible dangers and of his responsibility
for safety, both with regard to himself and to others. The operator is responsible for
securing the danger area by cordoning it off and taking protective measures (guards,
etc.) as necessary.
The wire saw is designed for a maximum cutting length of 2 m. The maximum distance
between the pivoting pulleys at the machine and the wire entry or exits points must not
exceed 3.5 m.
The wire saw may be operated only by specialists who have received training in concrete
cutting techniques. These persons must be completely familiar with the content of
these operating instructions and must have been trained by a Hilti specialist on the safe
application of these instructions.
National regulations and laws, as well as the operating instructions and the safety
information applicable to the accessories used (e.g. sawing wire, fastening accessories,
lifting equipment, compressor, etc.) must be observed.
Do not use the saw to cut loose objects or objects held by hand against the sawing wire.
Advance direction selector lever
(
(up/neutral/down)
Emergency off button
)
Main switch
+
Drive "Off" (red)
§
Wire speed adjustment in m/s
/
Drive "On" (green)
:
Clear button
∙
of greater than or equal to 350.
SC
SC
English
13
Advertisement
