Table of Contents
Advertisement
Remove the filter holder (10), empty out any coffee grouts and
fill it up with 1 or 2 servings of ground coffee, depending on
the filter holder used.
Press the ground coffee in filter down uniformly, using the
grinder/doser presser.
Remove any residues of ground coffee from the filter rim.
Fit and tighten the filter holder (10) on the coffee dispenser
unit, positioning the cup (or cups) under the nozzle (or nozzles)
of the filter holder (10).
DT version. Press the coffee dispensing push button (16,
17, 19, 20) for the required serving; the machine will stop
automatically.
Press the push button (18) for continuous dispensing.
Dispensing, whether for dosed servings or in the continuous
dispensing mode, can be interrupted at any time by pressing
the STOP push button (18).
C version. Press the coffee dispensing button (2) and
dispense.
When the desired dose is obtained, press button (2) again to
stop dispensing.
Scalding hazard! Use the appropriate insulating
devices (A) to move the water and steam wands.
Steam dispensing
Complete immerse the left or right steam nozzle (6) (if
supplied) in the container with the beverage to be heated.
Turn the steam adjustment knob (7) counter-clockwise.
Wait until the beverage has reached the desired temperature.
Afterwards, turn the knob (7) clockwise to stop the steam from
exiting.
Note. At the conclusion of each steam dispensing phase,
clean the inside of the steam nozzle as follows: turn the nozzle
towards the cup tray and carefully activate steam dispensing
at least once.
Heating milk for frothy coffee (cappuccino)
General indications
Milk is a delicate biological product and can easily deteriorate.
Heat modifies its structure. Milk must be kept at a storage
temperature no higher than 5°C (41°F) from the moment the
container is opened and throughout its entire period of use.
Our storage appliances are suitable for this purpose.
NOTE: at the end of the work day (or not more than 24 hours
from the time the container is opened), any remaining milk
must be discarded.
Use a tall narrow jug and fill it up to about the half-way mark.
Then plunge the steam jet pipe (6) into the milk.
Gradually open up the steam tap (7) and heat the milk for a
few seconds.
9. Delivery of the coffee
DT
C
10. Other hot beverage
When the amount of foam and sufficiently warm temperature
are reached, stop the steam by turning the knob (7) in the
opposite direction.
When the steam jet pipe (6) is no longer required, clean it
thoroughly with a sponge and a clean cloth.
Dispensing hot water
Place a container beneath the hot water tube (8) and turn the
hot water dispensing knob (9) counter-clockwise.
When the desired amount is reached, stop the hot water by
turning the knob (9) clockwise.
28
16
19
10
10
9
8
A
18
17
20
2
7
A
6
Advertisement
Table of Contents
