Table of Contents
Advertisement
11. Programming the coffee measures (only DT version)
How to access the programming function
To enter the programming mode, press push button (18) and
keep it pressed for about 8 seconds; the blinking LED light
sequence above the keys and the intermittent buzzer indicates
that the machine is in the programming phase.
To exit the programming mode, after programming the various
drinks, press push button (18) again.
"Before programming the coffee dispensing push
buttons fill the filter holder with the correct serving
of ground coffee. Don't use coffee grouts for pro-
gramming servings."
Fit and tighten the filter holder (10) on the coffee dispenser
unit, positioning the cup (or cups) under the nozzle (or nozzles)
of the filter holder (10).
Press (and keep momentarily pressed) the coffee dispensing
push button (16, 17, 19 or 20) corresponding to the required
serving to be programmed; the LED of the key to be
programmed stays on and does not blink.
When the amount of coffee in the cup reaches the required
level, release the coffee dispensing push button.
Repeat the above operations for the other coffee push
buttons.
Note: if you make a programming mistake, use a new dose of
ground coffee and repeat the operation.
11.1 Programming the Drying time (when provided)
The drying phase allows the coffee dispensing panel to dry
and sends water inside of it to the drain tube.
At the end of each dispensing cycle, the drying time counter
starts (the factory setting is 5 seconds for all keys).
To program a longer or shorter drying time, please follow
these steps:
Press and hold down any STOP/prog (
•
8 seconds. The sequenced blinking LED lights above the
keys and the intermittent buzzer indicate that the machine
is in the "coffee dose" programming phase;
•
Press and hold down the STOP/prog (
dispensing group: a different buzzer sound indicates that
the machine is in the drying time programming phase;
•
Press any dispensing key (
down for the seconds you want to assign for the drying
time. Afterwards, release the key;
•
At the end of the "
drying time " programming procedure,
press a STOP/prog (18) key to return to the coffee dose
programming level;
•
Press a STOP/prog (
18) key again to exit the programming
menu.
Note: Accessing the Drying Time programming screen zeros
the 5 second factory setting for all keys.
18) key for about
18) key for the left
16, 17, 19 or 20) and hold it
16
19
Start
dispensing
Dispensing EV ON
Dispensing EV OFF
Dispensing Time
Drying EV ON
29
18
17
20
10
Drying EV OFF
Drying time
Advertisement
Table of Contents
