Sump Gasket; Installing Sump Module; Ultra-Fine Filter - Haier GE GDF450P R0 Series Technical Service Manual

Sump Gasket

Stressing or softening the gasket ribs (pressing
the ribs against a hard surface, see below) will
make a new gasket seat easier. Lubricating with
a small amount of rinse agent or water will also
ease installation.

Installing Sump Module

While inserting the sump assembly back into
the tub, use care to ensure the sump assembly
wiring and components are not pinched between
the sump and the tub.
NOTE: Using rinse aid or water on the sump
gasket will aid sump installation.
1. Reconnect wiring to the pumps and flood
switch. Do not connect the turbidity sensor
until after the sump module is back in place
(step 5) to prevent damage to the connector.
2. Align the main conduit connection out of the
diverter on the sump module to the rear of the
tub and main conduit.
3. Press firmly into place, using both hands to
push down on the sump module.
4. Latch the three sump latch cams. The latch
cams must not be used to pull the sump
module into place.
5. Connect the turbidity sensor and high drain
loop hose.

Ultra-Fine Filter

Good filtration is key to good wash performance.
The ultra-fine filter and basket assembly is
consumer removable with a twist lock design.
The Owner's Manual advises the consumer
to remove and clean every 60 days or more
frequently depending on use.
NOTE: Using brushes or scouring pads will
damage the filter. To remove, turn the filter
counter-clockwise (CCW) and lift from the sump.
Ultra-Fine Filter
The ultra-fine filter and basket assembly can be
separated and cleaned to remove any debris that
has been captured.
Ultra-Fine
Filter
– 21 –
Basket