Operation And Cycle Information - Haier GE GDF450P R0 Series Technical Service Manual

2020 plastic tub value model dishwasher

Hide thumbs

Table Of Contents

Table of Contents

This section of the guide provides details on segments of cycles, timing of cycles, temperature

expectations, and cycling of the heater during the dry portion of a cycle.

Auto Hot Start

At the beginning of the main wash, the dishwasher checks the temperature of the water, and if it is

below 90°F, then it will add up to 10 minutes of time to heat the water to 90°F by circulating the water

while the heater is on. Similarly, at the beginning of the final rinse, the dishwasher will check the water

temperature, and if it is below 105°F, then it will add up to 15 minutes of time to heat the water to 105°F.

Once it reaches the target temperature, any remaining hot start time will be truncated and will continue

on with the cycle.

The cycle chart below explains the segments of a cycle (cycles for all models included, but not all

models contain the same cycles). It details fill and drain times which depend on either a full or partial

drain. It provides the circulation time in each segment but does not include turbidity or temperature

adjustments or dry cycles (see the Dry System, under the Tub section in this guide). Times will vary

depending on turbidity response and incoming water temperature.

Cycle Option Selected

Options

Temp

Boost

Sani-

Steam

Temp

Boost

Sani-

Steam

Temp

Boost

Sani-

Steam

Temp

Boost

Sani-

Steam

Sani-

Temp

Steam

Boost

Temp

Boost

Sani-

Steam

Sani-

Temp

Steam

Boost

Sani-

Temp

Steam

Boost

Sani-

Temp

Steam

Boost