Outer Door Panel - Haier GE GDF450P R0 Series Technical Service Manual

To Separate the Door
1. Remove the door.
2. Place the door on a protected surface to
prevent damage (the inner door facing up).
3. Remove the two 1/4-inch hex-head screws.
4. Slide the outer door panel away from the
console or control panel, approximately 3/4
inches.
5. Lift to separate inner and outer door panels.
To Reassemble the Door
1. Place the outer panel face down on a
protected surface.
2. Place the inner door face up, and position six
attachment tabs into the cutouts of the outer
panel.
Outer door has cutouts to
receive inner door tabs
3. Press the tabs firmly together while sliding the
inner panel onto the outer panel, using care
to make sure the outer panel mates properly
to the front or top console. The illustration
below has a portion of the door sectioned or
cut out to show the outer door panel engaged
with the attach tabs of the inner door.
4. Reinstall screws and reinstall the door.

Outer Door Panel

The outer door panel consists of hinge arms and
outer panel.
Hinge Arm Removal
1. Remove and separate the door.
2. Remove six 1/4-inch screws from the bottom
of the door panel.
– 51 –