Haier GE GDF450P R0 Series Technical Service Manual page 50

8. Locate the right door balance cable and insert
an Allen wrench or tool formed into a hook (as
shown below).
9. Lift the right cable up and slide it down and
away from the dishwasher. Do not release
tension from the cable.
10. Slide the right cable into the cable holder to
prevent spring from disconnecting from the
cable.
Caution: If the cable is released, the spring and
cable may become disconnected. Depending
on the model and installation, reconnecting may
require the dishwasher to be removed from
installation.
11. Standing in front of the dishwasher, open the
door a few inches, then lift the door and hinge
arms off of the offset legs.
Door Reinstallation
1. Let the door hang vertical and start by guiding
the door onto the hinge arms.
2. As the door drops approximately 2 inches,
let the top of the door fall away from the
dishwasher and it will drop into place.
WARNING: GEA Factory Service Technicians
are REQUIRED to follow Lockout / Tagout
(LOTO) 6 Step Process prior to beginning
repair.
– 50 –