Tub Gasket - Haier GE GDF450P R0 Series Technical Service Manual

To remove the lower rack brackets, insert a
flat-blade screw-driver under the tab and pry up.
Then slide the assembly off of the rack
Pinch the clips inward and pull the rollers off of
brackets. Note: When reinstalling the rollers onto
the bracket, ensure clips are fully engaged by
tugging on the rollers.
Clips

Tub Gasket

Tub Gasket
The tub gasket seals the top and sides of the
tub to the door. The retainer is molded into the
PermaTuf Tub. The seal pushes into the retainer
area of the tub, and no sealant or RTV is used to
install the tub gasket. There is a stop molded into
the tub to provide a proper position end point for
the gasket.
Tab
Clips
– 31 –
Tub
Gasket
Tub
Gasket
Track
Tub
Gasket
Stop
Tub Gasket Installation
1. The center of the gasket has a mark
which is placed pointing to the inside of
the dishwasher. This position will orient
the gasket wiper to face the inside of the
dishwasher and to the inner door.
(Top of Dishwasher)
Tub Gasket
Retainer Track
Center Position
Mark
2. Start by placing the mark down and align with
the tub latch. Push the gasket into the track,
working outward to the top corners.
3. Push the gasket into the track through the
corners, making sure the wiper portion of
the gasket does not turn inward or outward
causing the gasket to not have an even plane
around the corners. Stretching the gasket
may cause the gasket to roll in or out, which
will cause the new gasket to leak. If the
gasket wiper rolls in or out, pull the gasket out
of the track and reinsert into place.
The wiper on the Gasket
must make a smooth turn
through the corner
4. Continue to push the gasket into the track to
the track stopping point at the bottom of the
tub.
(Front of Dishwasher)
Wiper
Flange
(Continued next page)