Table of Contents
Advertisement
Labels and Areas
Multiple labels can be created in one label file, with each new label being inserted immediately after
the current label.
Areas are used to apply different formatting (such as justification, rotation, and frames) to different
parts of a single label. Areas can only be added when using a continuous label supply set to auto
length mode (see
labels that have pre-defined areas.
Note: You cannot set a fixed length of an area on a label that has multiple areas. The size of the
area is based on the amount of data entered and the font size of that data.
Add Label or Area
To add a label to a label file:
1. Press LABEL.
2. Choose Add.
The new label is inserted immediately after the current label and its number is reflected in the upper
right corner of the screen. Each label added will be of the same label type.
If the existing label had multiple areas, the added label has the same number of areas and the font
size from the first line of data in each area is retained.
To add an area to a single label:
1. Press FN and AREA.
2. Choose Add.
A new area is inserted immediately after the current area and its number is reflected in the upper right
corner of the screen. The font size used on the first line of the previous area carries over to the new
area.
Only the current area displays on the editing screen. Use the print preview to view the entire label. See
"Preview" on page
Note: Area can only be used on continuous label supply.
Label Length
Auto length is the default for continuous label supplies. With the length set to Auto, the label will be as
long as it needs to be to accommodate the entered data, up to a maximum of 40 inches. You can,
however, set a fixed length for a label. A different length can be set for each label in a file.
Note: To change the unit of measure for the length see
information.
To change the length of the label:
1. Press the LABEL key.
2. Select Length, then Fixed.
Note: Length is not available if you are using a pre-sized label supply.
M610 Label Printer User Manual
"Label Length" on page
28. To navigate between areas, see
36). However, area formatting can be applied to pre-sized
"Go to Label or Area" on page 37
"Units of Measure" on page 8
Editing Labels on the Printer
Labels and Areas
for more
36
Advertisement
Table of Contents
