Terminal Block, Patch Panel, 66-Block - Brady M610 User Manual

Terminal Block, Patch Panel, 66-Block

Terminal Block, Patch Panel, and 66-Block label types are designed to be used with continuous label
supply. If continuous label supply is not installed, these label types do not display in the menu. To
maintain correct spacing or add to the label prior to cutting, you can choose to disable feeding to cut
after printing.
To create terminal block, patch panel, or 66-Block labels:
1. Press LABEL TYPE.
2. Select Terminal Block, Patch Panel, or 66-Block.
The printer displays the settings screen for terminal block, patch panel, or 66-Block labels. All
three types contain the same settings.
3. If you are going to set up a sequence to enter data, select Serialize to place a check mark in
the option box. If you will manually enter data, leave the box empty.
If you intend to use serialization, you do not need to enter the Number of Terminals. The
serialization values determine how many labels to create.
4. In the Terminal Repeat field, indicate the size of the gap between each terminal (with a
minimum of 0.2 inches).
5. In the Number of Terminals field, enter the number of terminals on the block for which the label
is intended.
This field is not available if you selected Serialize. In that case the sequence values determine
how many labels to create.
6. When No Feed is selected, additional information can be added to the label after printing.
Press the PRINT key to keep printing the same information, otherwise enter new text and
press PRINT again.
Press the FEED key to cut the label.
7. From the Separator drop-down menu, select None, Line, or Tic to mark the division between
labels.
8. From the Orientation drop-down menu, select either Vertical or Horizontal.
9. When finished, navigate to OK and press ENTER.
M610 Label Printer User Manual
Line Separator, Vertical Orientation
Terminal Block, Patch Panel, 66-Block
Tic Separator, Horizontal Orientation
Label Types
59