Wireless Regulatory Information - Brady M610 User Manual

Wireless Regulatory Information

Applies only to the wireless printer model which supports Bluetooth wireless communication.
Regulatory markings, subject to country certification, are applied to host printer signifying Bluetooth
(radio) approvals have been obtained.
Radio protocol
RF Operating Frequency
RF Output Power
Antenna Type \ Antenna Gain
Environmental Operation
Environmental Storage
United States
Note: This equipment has been tested and found to comply with the limits for a Class A digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference when the equipment is operated in a
commercial environment. This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instruction manual, may cause
harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful interference in which case
the user will be required to correct the interference at own expense.
Changes or modifications not expressly approved by the party responsible for compliance could void
the user's authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference and, (2) this device must accept any
interference received, including interference that may cause undesired operation.
RF exposure guidelines / Important note: This equipment complies with FCC SAR exemption limits
set forth for an uncontrolled environment and properly used as instructed.
M610 Label Printer User Manual
WARNING! Operation of the device without regulatory approval is illegal.
2.402 – 2.480 GHz
< +20dBm EIRP (100mW)
PCB trace antenna \ +2 dBi
-40 to 85° C (-40° to 185° F)
Note: Be mindful of the maximum operating temperatures for the
printer. See "Physical and Environmental Characteristics" on
page 1.
-55 to 125° C (-67° to 257° F)
Note: Be mindful of the maximum storage temperatures for the printer.
See "Physical and Environmental Characteristics" on page 1.
Wireless Regulatory Information
Bluetooth Low Energy
Regulatory Compliance
106