Wireless Regulatory Information; United States - Brady BradyJet J2000 User Manual

Wireless Regulatory Information

Regulatory markings, subject to country certification, are applied to host printer signifying wireless
approvals have been obtained. For a complete list of approved countries, go to
www.BradyID.com/J2000compliance

United States

Note: This equipment has been tested and found to comply with the limits for a Class A digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference when the equipment is operated in a
commercial environment. This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instruction manual, may cause
harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful interference in which case
the user will be required to correct the interference at own expense.
Changes or modifications not expressly approved by the party responsible for compliance could void
the user's authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference and, (2) this device must accept any
interference received, including interference that may cause undesired operation.
BradyJet J2000 Color Label Printer
Operation of the device without regulatory approval is illegal.
WARNING!
Radio protocol
RF Operating Frequency
RF Output Power
Antenna Type
ISO15693 compliant RFID reader/writer
13.56 MHz
< +20dBm EIRP (100Mw) < +23dBm (200mW)
PCB loop antenna, 2.5
μ
Regulatory Compliance
H @ 13.56 mHz
33