Carrier CDII-184R1-0CTR4 Installation & Operation Manual page 37

CAUTION
Transportation
• Transport the product using the correct method that corresponds to the weight failure
to observe this could lead to injuries.
• Do not stack the inverter boxes higher then number recommended.
• Ensure that installation position and material can withstand the weight of the inverter.
• Install according to the information in the instruction manual.
• Do not hold or carry this inverter by cover it may fall off or fail.
• Do not drop, hit, or shake the driver, the internal circuit and mechanism may result.
• Do not install or operate a damaged drive or and driver with missing parts, as electric
shock or injury may occur.
• Do not stand or rest heavy object on the product.
• Check the inverter mounting orientation is correct.
• Use the inverter under the following environmental condition: otherwise the inverter
may be damage.
WARNING
Wiring
•
Connect the inverter to power via a line-protection molded-case circuit breaker or
fuse, as fire may result. always connect a grounded wire, as electric shock or fire
may result.
• Wiring should be performed only qualified personnel or a licensed specialist failure to
observe this warning can result in an electric shock or a fire.
• Turn off the power and verifying that power supply is turned off before wiring, as electric
shock may result. Failure to overserve this warning can result in an electric shock or a fire.
• When wiring the emergency stop circuit, an external control interface, check the
wiring thoroughly before operation. Failure to observe this warning can result in an
electric shock or a fire.
• Make sure to ground the ground terminal according to the local grounding code. Failure
to observe this warning can result in an electric shock or a fire.
• Verify that the inverter rated voltage and phase coincides with the AC power supply
voltage. Failure to observe this caution can result in an electric shock or a fire.
• Do not connect the output cables (U,V,W) to the AC power supply, as damage may
result.
• Make sure to tighten screws of the main circuit and the control circuit. Failure to observe
this caution result in an electric shock or a fire.
• The connection orientation of the output cable (U,V,W) to the compressor will affect the
direction of rotation compressor.
37