Jtag Emulation Port; Jumper And Switch Settings - Analog Devices ADSP-BF535 EZ-KIT Lite Manual

JTAG Emulation Port

The JTAG emulation port allows an emulator to access the processor's
internal and external memories through a 6-pin interface. The JTAG
emulation port of the processor also connects to the USB debugging inter-
face. (Note that this is not the processor's USB interface.) When an
emulator connects to the board at
abled. See "JTAG (P8)" on page 2-14
To learn more about available emulators, contact Analog Devices (see
"Product Information").

Jumper and Switch Settings

This section describes the function of the board's jumpers and switches.
Figure 2-2 on page 2-6
Figure 2-2. Jumper Locations
ADSP-BF535 EZ-KIT Lite Evaluation System Manual
ADSP-BF535 EZ-KIT Lite Hardware Reference
, the USB debugging interface is dis-
P8
for more information.
shows the location of the jumpers and switches.
2-5