MINOLTA-QMS 4060 Service And Parts Manual page 567

Drive Unit E to Ejection Unit Belt Replacement Procedure
Part Number
CA98001-6942
Tools Required
Magnetized 8-inch, number-2 Phillips-head screwdriver
Replacement Procedure (removal)
Step Instruction
1.
Open ejection unit cover
2.
Open upper-right cover
3.
Remove top cover
4.
Remove rear cover
5.
On ejection unit gear bracket, loosen 2 screws
6.
Lift belt off top and bottom gears
Replacement Procedure (mounting)
1.
Install new belt on gears
2.
Verify that bracket positioning pin is inside the positioning slot
CAUTION
3.
Do not overtighten belt.
Position the bracket so that the belt is tight but has just a little depression
when you press down on the belt
4.
Close all covers
SERVICE MANUAL
Comment
Notice that the bracket has elongated screw
slots to adjust belt tension. Also note the
positioning pin in the 3rd slot.
Note the belt path
6-84