MINOLTA-QMS PagePro 9100 Series Quick Start Manual page 122

25. Remove the heat roller (1 heat roller stop ring, 1 bushing, 1 bearing, 1 insulating material, and 1
thermal insulating plate).
26. Remove the compression roller.
1
2
A
3
1 Heat roller stop ring
2 Bushing
3 Compression roller
4 Insulating bushing
5 Bearing
6 Heat roller gear
7 Thermal insulating plate
8 Heat roller
Note
• When handling the heat roller and the compression roller, touch only the ends of the rollers or the
roller shafts. Do not touch the surface of the rollers with your hands.
• Never allow the surfaces of the heat roller and compression roller to become scratched or con-
taminated with chemicals or toner, etc. Any scratching or contamination of the rollers will affect
printing quality.
• When installing a compression roller, first insert end A of the compression roller shaft into the
frame of the fusing unit, and then insert end B of the shaft.
8
B 4
114
7
6
5
1