2. Remove the coil spring.
3. Remove the collar from the shaft.
4. Pull the shaft out of the paper-separating roller assembly.
5. Remove the bracket.
1 Shaft
2 Paper-separating roller assembly.
3 Coil spring
4 Bracket
5 Collar
Note
• Never touch the surface of the paper-separating roller or allow it to become contaminated with
chemicals or toner, etc. Any scratching or contamination of the paper-separating roller will affect
paper feeding.
• When installing a paper-separating roller assembly, make sure that the paper-separating roller
assembly fits up against the left side of the bracket, and then install the collar. At that time, make
sure that the space between the paper-separating roller assembly and the bracket is between 0.5
and 1 mm, as shown in the illustration. After installing the paper take-up roller, make sure that the
it fits against the front paper separator guide.
• Be sure to install the coil spring as shown in the illustration.
Paper-separating roller
assembly.
Bracket
1
A
OK
104
2
3
4
5
No Good