MINOLTA-QMS PagePro 9100 Series Quick Start Manual page 116

Note
• When installing the rear (left) cover, make sure that the tabs on the cover securely hook onto the
frame of the fusing unit.
5. Peel off the seal.
6. Remove the front cover (3 screws and 1 connector).
7. Remove the screws securing the thermistor assembly (2 screws), and then turn over the ther-
mistor assembly.
8. Remove the screws securing the cable to the heater (H1) (2 screws).
1305
1 Thermistor assembly
2 Front cover
3 Seal
Note
• When installing the front cover, make sure that the harness of the thermistor assembly is not
pinched between the front cover and the frame of the fusing unit.
1305
1
3
108
2
1308
1308
1308