Cd Player; Connecting A Cd Player; Connecting A Turntable - Onkyo TX-SR703 Instruction Manual

TX-SR803_En.book Page 33 Friday, August 26, 2005 9:26 AM
Connecting Your Components —Continued

Connecting a CD Player

Step 1:
Choose a connection that matches your CD player ( ,
b
COAXIAL
IN 2
c
OPTICAL
IN 3
Connect one
or the other
• With connection , you can listen to and record audio from the CD player and listen in Zone 2.
a
• To connect the CD player digitally, use connection
Connection
a
DIGITAL COAXIAL IN 2
b
DIGITAL OPTICAL IN 3
c

Connecting a Turntable

The AV receiver's PHONO IN is for use with a moving
magnet (MM) type cartridge.
Use an analog audio cable to connect the AV receiver's
PHONO IN L/R jacks to the audio output on your turn-
table.
Notes:
• If your turntable has a ground wire, connect it to the
AV receiver's GND screw. With some turntables, con-
necting the ground wire may produce an audible hum.
If this happens, disconnect it.
• If your turntable has a moving coil (MC) type car-
tridge, you'll need a commercially available MC head
amp or MC transformer. Connect your turntable to the
head amp or transformer, and connect that to the AV
receiver's PHONO IN L/R jacks.
• You can also use a phono equalizer to connect a turn-
table with an MC-type cartridge. See the phono equal-
izer's manual for details.
, or
a b
a
IN
L
R
CD
COAXIAL OPTICAL
OUT
or
b
AV receiver Signal flow
⇐
CD IN L/R
⇐
⇐
), and then make the connection.
c
L R
AUDIO
OUT OUT

CD player

. (For recording, use and
c a
CD or turntable
Analog audio L/R output
Digital coaxial output
Digital optical output
, or and .)
b a c
IN
L
R
PHONO
AUDIO
OUTPUT
L
R
33