Onkyo TX-SR703 Instruction Manual page 55

TX-SR803_En.book Page 55 Friday, August 26, 2005 9:26 AM
Listening to the Radio —Continued
ON STANDBY
V1 V2
1
V4 MULTI CH
4
CD TAPE
7
PHONO
+ 10
10
- - /-- -
INPUT SELECTOR
MACRO
1
REMOTE MODE
1
RECEIVER DVD
TAPE/AMP
TV VCR
DIMMER
2, 3
+
CH
DISC
ALBUM
-
PREV
CH
DISPLAY
REC
LISTENING MODE
STEREO SURR
Positioning the XM Antenna
You can check the signal strength of the XM radio signal
and adjust the position of the XM antenna accordingly.
1
Press the remote controller's
RECEIVER
[RECEIVER] button, followed by
the [SETUP] button.
2
Use the Up and Down [
buttons to select "4. Input
Setup," and then press [ENTER].
ENTER
ENTER
3
Use the Up and Down [
buttons to select "3. XM Antenna
Aiming," and then press
ENTER
[ENTER].
4.Input Setup
-------TUNER-------------
1.Delay
2.Character Edit
ENTER
3.XM Antenna Aiming 3.XM Antenna Aiming
T V
I INPUT
V3
+
2 3
T V CH
DVD
5 6 -
TUNER
8 9
T V VOL
0 CLEAR
11 12
2 3 ZONE2
CD HDD
CABLE SAT
CDR MD
SLEEP
ENTER VOL
1, 5
MUTING
PLAYLIST RANDOM
]/[ ]
]/[ ]
4
Adjust the position of the XM
antenna so that the "Signal Qual-
ity" is at least 70%.
4-3.XM Antenna Aiming
-------TUNER-------------
a.Signal Quality
[
The signal quality range is 0% to 100%.
5 When you've finished, press the
[SETUP] button.
Setup closes.
Note:
If the signal quality is 0%, make sure that the XM
antenna is connected properly.
XM Radio Messages
The following messages may appear while using XM
radio.
The XM antenna is not connected properly. Check the
antenna.
The XM user encryption code is being updated. Please
wait.
The signal is too weak. Check the antenna connection
and reposition it for the best reception.
The AV receiver is tuning or decoding audio or text data.
Please wait.
The XM channel you selected is not currently broadcast-
ing. Select another channel.
:100%
| ]
55