Cd Player Operation; Cassette Tape Deck Operation; To Operate Cec-Compatible Components - Onkyo TX-NR535 Advanced Manual

G
H
I
, , , , , ,
G
A (Red), B (Green), C (Yellow), D (Blue)
H
Number 1~9, 0, +10
I
CLR, DISPLAY
J

CD player operation

Press the REMOTE MODE button programmed with
the remote control code for the relevant AV component
to switch the remote controller mode to that for the AV
component. Then, operate by using the corresponding
buttons. Available buttons vary depending on the product
category of the component. Note that some buttons may
not work, or the remote controller may not work at all with
some components.
1
REMOTE MODE
1
SOURCE
2
MUTING
3
DISC +/–
4
5
6
/ / / , ENTER
5
J
SETUP
6
7
8
9
, , ,
7
SEARCH, REPEAT, RANDOM, MODE
8
Number 1~9, 0, +10
9
CLR, DISPLAY
F

Cassette tape deck operation

Press the REMOTE MODE button programmed with
2
the remote control code for the relevant AV component
to switch the remote controller mode to that for the AV
component. Then, operate by using the corresponding
buttons. Available buttons vary depending on the product
category of the component. Note that some buttons may
3
not work, or the remote controller may not work at all with
some components.
4
Operating Other Components with the Remote Controller
F
, , ,
1
REMOTE MODE
1
SOURCE
2
MUTING
3
4
, (Reverse Playback), ,
4

To operate CEC-compatible components

The TV and BD/DVD buttons on the remote controller
are preprogrammed with remote control codes for linked
operation of some CEC (Consumer Electronics Control)-
compatible TV sets and Blu-ray Disk players. By connecting
to the unit via HDMI, you may operate them using the AV
receiver's remote controller.
⿠ If you cannot operate your CEC-compatible component,
program one of the following remote control codes to the
TV or BD/DVD button.
TV button: 11807/13100/13500 (CEC-compatible TV)
BD/DVD button: 32910/33101/33501/31612 (CEC-
compatible BD/DVD player)
Press TV/CD or GAME to display "TV/CD" or "GAME" on
the unit's display. Then, hold down TV/CD or GAME for 3
seconds to switch the input name to "DOCK" or "TAPE".
2
3
, , ,
33