Dismounting The Inline Modules; Fig. 8-2: Latching On A Module - Bosch Rexroth IndraControl L40 Project Planning Manual

8-4
Installation and Maintenance
A
C

Dismounting the Inline Modules

IAS COMPONENTS www.ias-components.com info@ias-components.com
B
D
Fig. 8-2: Latching on a module
Proceed as follows to remove a module (Fig. 8-3):
• Remove the labeling field, if present (A1 in Fig. A).
Note: If any of the modules is provided with more connectors than
one, all of these connectors must be removed from the
module. The sections below describe the removal of a 2-slot
module.
Pry out the connector of the module to be removed by pressing on the
rear connector shaft latch (A2 in Fig. A).
• Remove the connector (Fig. B).
• Remove the adjacent connectors of the neighboring modules (Fig. C).
This ensures that the feathers of the voltage jumpers and the
keyway/feather key joint are prevented from damage. Moreover, the
module can be accessed more easily.
• Actuate the release mechanism (D1 in Fig. D) and remove the
electronic socket perpendicularly to the top-hat rail (D2 in Fig. D). If
you have failed to loosen the connector of the neighboring module to
the left, this connector now loosens to protect the feathers of the
voltage jumper and the keyway/feather key joint.
IndraControl L40
Modulaufrasten.FH9
DOK-CONTRL-IC*L40*****-PR02-EN-P